PEM press in fasteners for PC boards
_403_large.jpg "PEM press in fasteners for PC boards")
PEM fasteners for PC boards allow the quick and simple installation of threads and standoffs into industry standard circuit board material. Clever design means that the fasteners take up minimum space on the board; and the broaching or flaring installation ensures that the board is not damaged during fitting.
PEM PC board fasteners can be used directly into the circuit board or through plated holes as required.
Internally threaded fasteners for mounting into P.C. boards. Thread sizes #2 to #10 and M2 to M5. KF2 and KFS2 fasteners are simply pressed into the prepared hole. once installed they provide a strong permanent thread in any printed circuit board material.
Standoffs available with or without threads for mounting into P.C. boards, for spacing or stacking.Thread sizes #4, #6 and M3.
Used to ground P.C. boards to steel or aluminum chassis. Annular projecting teeth eliminate the need for serrated or starwashers to make good electrical contact with the circuit foil. Thread sizes #4, #6, and M3, M4.
For spacing or stacking P.C. boards. Special shank is flared to increase pushout resistance. Thread sizes #4, #6 and M3, M4.
Accurately space a P.C. board from another board or metal chassis simply by snapping board on standoff.
Panel fasteners with spring-loaded captive screws for mounting into P.C boards. Thread sizes #4, #6, and M3.
Studs for mounting into P.C. boards which can be used as solderable connectors as well as threaded fasteners. Thread sizes #4 to #10 and M3 to M5.
PEM SFK series Spotfast® fasteners create a permanent, flush joining of metal to PCB/plastic panels. The fastener installs smooth with the top sheet, and flush or sub-flush with the bottom sheet.
New PEM® TK™TackSert® pins from Penn Engineering® introduces an ideal alternative to screws for attaching thin panels in assemblies. They can securely attach panels of any material to base panels manufactured from commonly used materials not suited to self-clinching techniques
The PEM® heat sink mounting system introduces an engineered solution to securely attach heat sinks to circuit boards while providing a firm and constant contact to the chip component for optimum heat dissipation. The system additionally integrates a unique audible "click" feature to prevent over tightening during installation, accommodates slight expansion and contraction of joint components without causing stress or damage to delicate and expensive circuitry, and allows for removal of the heat sink if necessary.
Used in plated thru-holes in multi-layer P.C. boards. The self-expanding shank ensures positive contact with plated thru-holes. Thread sizes #4 to #10 and M3 to M5.