PEM Self Clinching Studs
Threaded studs for use in most ductile metals including aluminium, steel and stainless steel. PEM self clinching studs are normally installed with flush heads - but are available with larger heads for use in heavy duty applications.
PEM studs come hardened as standard to ensure faultless, permanent installation and very strong threads in a variety of applications. Available in thread sizes from M2 to M10. Untrheaded versions are also available for pilot pin type applications.
External threads in sheets as thin as .020" / 0.51 mm. Included are flush- mounted studs, studs for thin sheets, high-strength studs, bus bar studs, studs for stainless steel, and non- threaded alignment pins.
Especially hardened Flush head studs for installation into stainless steel sheets as thin as 1.0 mm
Installs closer to the edge of a sheet than standard studs without causing that edge to bulge. Flush-head for sheets thickness .040"/1mm and greater.
TFH studs are for use in panels as thin as 0.51mm. TFH studs are available in metric thread sizes M3 to M5, plus a range of unified thread sizes up to 10-32.
Type HF109© clinch studs are specially heat-treated to achieve greater tensile strength up to Property Class 10.9 (metric) meeting 150 ksi/1040 MPa minimum. Their large-diameter heads serve to reduce compressive stress on panels and promote development of full thread strength.
These self-clinching studs have an enlarged head diameter that provides high-strength in sheets as thin as .040"/1mm.
Self Clinching Stud for installation into very hard thin steel
PEM® self-clinching concealed-head studs and standoffs install permanently in steel or aluminum sheets as thin as 1.6mm to provide strong and reusable threads for mating hardware in a wide range of thin-metal assembly applications. Their concealed-head feature contributes particular design benefits by allowing the side of the sheet opposite installation to remain smooth and untouched. This feature additionally serves to satisfy applications where the sheet must remain completely sealed from air, liquid, dust, gases, or other potentially infiltrating elements.
New PEM Flush-Head Studs With X-Press Threads Uniquely Designed For Quick Mating With Plastic Fasteners
PEM Type SGPC swaging collar studs can install into most panel materials, provide strong torque-out resistance and are suitable for close centerline-to-edge applications. They can also be installed into multiple layers of panels as long as the total thickness does not exceed the recommended maximum.